sudomod

https://www.thingiverse.com/thing:2383108

Print at 0.2 (0.3 you'll miss a layer under the gameboy zero text) and with supports.

Trim the PCB with a dremel. I can't remember what version screen I have as it's been a while.

Not my best print. I forgot to set the infill so it was at the last thing I printed which was a G clamp so the infil was 80%. Will probably reprint at 20% as the infill is overlapping the perimeter lines.

Looks great! Great job!

I'm pretty sure I have this same screen control board - can you share the STL? Looks like you took it off thingiverse.

Would be much appreciated I was goin to try to model my own until I found yours...