Kite's Circuit Gem - shoulder buttons?

General chat about the VMµ project (Raspberry Pi Zero inside a Sega Dreamcast VMU) goes here!
Post Reply
User avatar
HollandJim
Posts: 16
Joined: Sat Apr 15, 2017 1:10 am
Has thanked: 56 times
Been thanked: 7 times

Kite's Circuit Gem - shoulder buttons?

Post by HollandJim » Sun Feb 24, 2019 10:52 pm

This'll be my first build (once the battery arrives from China, of course) so I'm really excited, but I'm also an absolute noob; I'm tinning wires now just to build up soldering skills. That also implies I'm not sure what I'm looking at on the board, so it might be obvious but is there any support for shoulder buttons?
Quando omni flunks, moratati

User avatar
kite
Posts: 972
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 246 times
Been thanked: 361 times
Contact:

Re: Kite's Circuit Gem - shoulder buttons?

Post by kite » Sun Feb 24, 2019 11:53 pm

The included 3pin cable goes into the 3pin connector near the bottom of the board, if you wire it so that GND is common on both buttons, and each button has 1x wire of L1 and R1 respectively, they will be the L/R buttons when shorted to GND by the button.
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/


ImageImageImageImageImage

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest