Page 1 of 1
What did you glue your battery doors on with?
Posted: Wed Mar 13, 2019 4:35 pm
by Robochris
I’m afraid that super glue will look like... well, super glue. Just want something to look clean.
Re: What did you glue your battery doors on with?
Posted: Wed Mar 13, 2019 10:33 pm
by smoscar01
I have some tape holding them in place. Was worried about how warm they could get.
Now when it gets really warm I just remove it and blow some air on it. Was thinking about putting some adhesive velcro but it gets really bulky.
Re: What did you glue your battery doors on with?
Posted: Thu Mar 14, 2019 6:04 pm
by Damazeltov
Robochris wrote: ↑Wed Mar 13, 2019 4:35 pm
I’m afraid that super glue will look like... well, super glue. Just want something to look clean.
I used a very small amount of Loctite 401 at the two hinges and at the lower frame.
Re: What did you glue your battery doors on with?
Posted: Sun Apr 21, 2019 10:41 am
by vinomer
I always use JB Weld Clearweld for my projects. It bonds much better than superglue.
Re: What did you glue your battery doors on with?
Posted: Sun Apr 21, 2019 11:10 am
by KonnorJ
You can find epoxy that cures super clear
Re: What did you glue your battery doors on with?
Posted: Sat Dec 07, 2019 4:06 pm
by gmay3
I used a medium thickness CA super glue, just a couple 2 mm sized dots and that was plenty to get it bonded. I did it on a clear blue VMU and it didn't show up as looking glued.