How to cut shells for the PocketPi FE?
-
- Posts: 42
- Joined: Thu Jan 31, 2019 3:42 am
- Has thanked: 2 times
- Been thanked: 10 times
How to cut shells for the PocketPi FE?
I know there's a build video from wermy, but he had a few different parts iirc.
- KonnorJ
- Posts: 385
- Joined: Thu Jan 11, 2018 1:23 am
- Location: United Kingdom
- Has thanked: 58 times
- Been thanked: 109 times
- Contact:
Re: How to cut shells for the PocketPi FE?
Use the pcb to create a mark for the button holes, use a drill bit to 9mm then a step bit to 9.5mm, carefully turning it by hand until the buttons are able to move freely in the holes, then use a dremel and/or pliers and craft knife to cut out most of the rear cart section, dremel away all of the battery bay apart from the screw holes. Cut the right side of the screen bezel slightly and you are done.
Who is online
Users browsing this forum: No registered users and 1 guest