Fitting the Pi Zero into a custom printed cartridge

Need help with or have a question about your 3d printer? Ask it here!
Post Reply
User avatar
NyteFury
Posts: 29
Joined: Wed Jul 20, 2016 1:14 pm
Has thanked: 2 times
Been thanked: 8 times

Re: Fitting the Pi Zero into a custom printed cartridge

Post by NyteFury » Tue Aug 23, 2016 8:58 pm

I'm going to use at least part of the cart reader, and on the Pocket the fit is sooo tight with all the components and PCB button board that I don't think you could extend the cart into the case any length.
Gameboy Pocket Zero [in progress]: http://imgur.com/a/L87uk
Top
User avatar
NyteFury
Posts: 29
Joined: Wed Jul 20, 2016 1:14 pm
Has thanked: 2 times
Been thanked: 8 times

Re: Fitting the Pi Zero into a custom printed cartridge

Post by NyteFury » Fri Sep 09, 2016 12:08 pm

Got version 1.1 of the cart today. It still needs some work on the internals. Currently it's a little too tall to fit the in the gameboy, and there's not a hole for the SD card or HDMI port. Just wanted to let folks know there was progress and that it doesn't look as comical anymore.

[spoiler="version 1.1"]Image[/spoiler]
Gameboy Pocket Zero [in progress]: http://imgur.com/a/L87uk
Top
Post Reply

Return to “Support (3d Printing)”

Who is online

Users browsing this forum: No registered users and 1 guest