Hey everybody, I have a question about what you all think of the positioning of this board:
The ribbon forces the board pretty much to the far left. I cant move it because the ribbon is kind of "Z"-like, so even slightly moving it more to the right puts pressure on the ribbon itself, which I don't want to damage.
To those who have gone through this project: does it look like my board will be in the way of major components that wont be able to work around it? I am using a NON all-in-one pcb, meaning that I need to wire up the audio with the low pass filter and the teensy, which doesnt seem like it would be in the way anyway. I considered placing the screen upside down, but then the board would likely be in the way of the raspberry pi, which seems worse.
Any thoughts are greatly appreciated. I appreciate all of the help that I have found on these boards.
LCD Board positioning
- mike_louisxvi
- Posts: 41
- Joined: Sun Oct 23, 2016 1:25 am
- Location: California, US
- Has thanked: 18 times
- Been thanked: 8 times
Re: LCD Board positioning
So what I ended up doing was cutting @wermy 's board in two to allow my LCD board to fit with a teeny bit of slack so it wasn't all bunched up. It was also installed upside down (which turned out to not be needed anyway, but the hotglue was already done!)
Who is online
Users browsing this forum: No registered users and 1 guest