this might be a silly question.. but to be sure I would like to ask in this newly created and beautiful hardware HALP!!! section.
I already have a 6 pins small power switch, the dimensions are almost matching the adafruit ones used by wermy in his guide.
But it's a 6 pins (like the one used in the GBZ build)
Can I use it anyway? I figured I should just join the pins so that from 6 I get 3.. is that correct?
Maybe the fact that the pins are sticking out from the top might be a problem, but I can always trim them a bit.
Thank you very much
6 pins switchShow