[Solved] Button 5 Not Working

Post Reply
Mitaccio
Posts: 23
Joined: Thu Apr 27, 2017 1:07 pm
Has thanked: 2 times

[Solved] Button 5 Not Working

Post by Mitaccio » Sat Mar 17, 2018 7:26 pm

I have 3 of the v0.6 that I made with just the four button config and everything was working fine. I am adding the shoulder buttons from eriK_gee and running into an issue. I have the buttons wired as usual with the supplied wire harnesses and am running into an issue with mapping. Every time I try to map the R button to button 5 I get nothing. I have tried swapping the wiring harness from L and R to see if it's a connection issue, but the problem is specifically mapping to button 5. I have no idea what I need to check/do next. Any help?

User avatar
kite
Posts: 860
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 227 times
Been thanked: 289 times
Contact:

Re: Button 5 Not Working

Post by kite » Sun Mar 18, 2018 1:58 am

Picture of what you are connecting them to? You can use ANY of the L1/L2/R1/R2 ports, it doesn't matter about their name, as you map it in gui.. so just use another one

Mitaccio
Posts: 23
Joined: Thu Apr 27, 2017 1:07 pm
Has thanked: 2 times

Re: Button 5 Not Working

Post by Mitaccio » Sun Mar 18, 2018 2:39 pm

I figured it out. I assumed that the wiring harness for the back buttons would use black as the ground, not the yellow.

User avatar
jothie
Posts: 17
Joined: Mon Jul 18, 2016 2:20 am
Has thanked: 8 times
Been thanked: 1 time

Re: [Solved] Button 5 Not Working

Post by jothie » Sun Jun 10, 2018 7:23 am

Hurm, I'm having the same problem. Everything works but R1. I've desoldered and resoldered it with same results. Black is showing as ground to me not yellow. Maybe a mix up on some boards. If you used yellow as ground did you use black as button(or the red?)

User avatar
kite
Posts: 860
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 227 times
Been thanked: 289 times
Contact:

Re: [Solved] Button 5 Not Working

Post by kite » Mon Jun 11, 2018 7:15 am

Show a picture of how you have it connected :) or planning to

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests