So I know some people might say that I should just wait for v3.0, but here's the story:
About a year ago, I was going to build a mintyPi, and when Helder's v2.0 boards came out, (http://market.sudomod.com/mintypi-scree ... n-pcb-set/ these ones) I was lucky enough to get one. Over the next couple of months, the whole thing kind of phased out of me. And I kind of forgot about it. So about two weeks ago, I said to myself, I should come back to mintypi. And because I already had the Helder boards, I didn't want to not use them.
Anyway, enough with my life story, here's my build Log !
Hey! Almost Forgot about this Log! If you've been following my instagram (@diynitro) then you have seen this already, but just in case you haven't here's what's been happening
I have the following Parts:
The Screen, Button PCB 2.0 and the Tin
The Updated 3D Printed Parts
Thanks! I'll post for the next part, which will be the Raspberry Pi Zero W
Show off your completed mintyPi, or post your build logs here!
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests