Difference between revisions of "GBZ Misc Hardware"
From sudomod
m |
m |
||
| Line 16: | Line 16: | ||
==Micro SD Card== | ==Micro SD Card== | ||
[http://www.banggood.com/32GB-Class-10-Micro-SD-TF-Micro-SD-Card-For-Mobile-Phone-p-975787.html?p=9B1915347037201311DI 32 Gb micro SD card] to install RetroPi on and roms. | [http://www.banggood.com/32GB-Class-10-Micro-SD-TF-Micro-SD-Card-For-Mobile-Phone-p-975787.html?p=9B1915347037201311DI 32 Gb micro SD card] to install RetroPi on and roms. | ||
| + | |||
| + | ==Prototype PCB== | ||
| + | [http://www.banggood.com/10Pcs-5X10cm-Single-Side-Copper-Prototype-Paper-PCB-Breadboard-2-3-5-Joint-Hole-p-1043222.html?p=9B1915347037201311DI Protoytype PCB] to create power distribution board or GPIO sound output for the RPi Zero. | ||
Revision as of 08:52, 17 July 2016
Contents
GPIO PWM Audio for Raspberry Pi Zero
150 Ohm resistor, 270 Ohm resistor, 10nF capacitor, and a 33nF capacitor (another 10nF will work fine as well if that’s easier to find)
L/R Buttons
If you want to use tactile switches in the rear screwholes like the original GBZ, you'll need something similar to this: http://www.amazon.com/9-5mm-Momentary-Tactile-Button-Switch/dp/B008420WOA or this
Replacement case
A replacement case for the gameboy can be found here.
Audio Jack
In case you can not use the audio jack of the original GBZ board here is a replacement.
Power Switch
If you don't have the power switch from the GBZ board or are unable to desolder it you can use this switch.
Micro SD Card
32 Gb micro SD card to install RetroPi on and roms.
Prototype PCB
Protoytype PCB to create power distribution board or GPIO sound output for the RPi Zero.
