|
|
| Line 1: |
Line 1: |
| − | ==Common Problems and How to Fix Them==
| |
| | | | |
| − | ===Kits Received After April 2019===
| |
| − |
| |
| − | ====After flashing the new image, the boot logo screens do not appear at all====
| |
| − | The MintyPi and Sudomod boot logos were both removed in the lastest image. Expected behaviour.
| |
| − |
| |
| − | ====I have no sound!====
| |
| − | The most common problem is that the GPIO pins have not been soldered correctly. Use the image below to make sure you have continuity between the test pads and the Pi marked in red on the left side. Also make sure that you are getting 5v from the Pi to the SMD marked in red on the right.
| |
| − |
| |
| − | [[File:MintyPi_v3_Audio.png|800px]]
| |
| − |
| |
| − | Also check the chip to make sure you have 5v power going from the 5v marked on the pi pictured above to those 2 pins. You may have to reflow those pins. Do this while it is not powered and make extra sure you don't have any bridges between the pins after reflowing.
| |
| − |
| |
| − | [[File:V3_sound_chip.jpg|600px]]
| |
| − |
| |
| − | ===Kits Received Before April 2019===
| |
