Hello everyone,
Reaching out to see if there's any interest in buying pre-cut mintyPi tins. I picked up a few Dremel bits that made the process extremely effortless.
If you're interested please post a comment below and let me know how many you'd like and what colors. If there's enough interest I'll put a price up and offer them for sale. I'm only going to offer standard colors that I can find in the supermarket.
(The green tin is a perfect cut. The red tin is a little wide on the charging port.)
mintyPi Tin Cutting Service (U.S. for start)
- dryja123
- Posts: 1076
- Joined: Tue May 09, 2017 5:34 pm
- Location: Central NJ
- Has thanked: 239 times
- Been thanked: 553 times
mintyPi Tin Cutting Service (U.S. for start)
Guide for troubleshooting mintyPi power problems: http://www.sudomod.com/forum/viewtopic.php?f=34&t=4115
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
Re: mintyPi Tin Cutting Service (U.S. for start)
how much would these cost? I would rather not pay more than like $7-ish
- dryja123
- Posts: 1076
- Joined: Tue May 09, 2017 5:34 pm
- Location: Central NJ
- Has thanked: 239 times
- Been thanked: 553 times
Re: mintyPi Tin Cutting Service (U.S. for start)
Idk haven't really received any interest on the service. If there was demand I was going to buy empty tins in bulk off eBay. Is there a particular color you want? $2.50 for a tin of Altoids plus shipping adds up to about $7 so I'm doing you a favor. Let me know and if I get some free time I'll try to cut one for you.
Guide for troubleshooting mintyPi power problems: http://www.sudomod.com/forum/viewtopic.php?f=34&t=4115
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
Who is online
Users browsing this forum: No registered users and 1 guest