firestw152 wrote: ↑

Thu Oct 12, 2017 12:09 pm

Is this the pro micro? http://www.ebay.com/itm/2X-Leonardo-Pro ... SwDrlZfNLO


I would like to add the adafruit joystick or maybe a psp one to my build.

Yes, that is the same one I am using.

firestw152 wrote: ↑

Sat Oct 07, 2017 1:40 pm

How are you connecting the joystick to the pi?

The sticks have 6 pins, 4 of which are connected in pairs. I connect GND to ground, VCC to VCC and the outputs to the analogue inputs on my pro-micro.

I've been comms-quiet recently, as term 4 of school started this week. I got my composite screen in the post and it works! https://i.imgur.com/mzx1n3W.jpg However, I noticed the screen was off-centre, and realised that it was because the glue had come off and the actual LCD module was rattling aroun...

Did you get it working? I can't seem to get mine to work at 5v, even when bypassing the regulator.

EDIT: Got it working, just had to connect it to SW, not BST.

The voltage regulator is this one: http://www.datasheetspdf.com/PDF/JW5022/1101093/2 It's the eight pin chip in the corner of the board, if you attach your 5v wire to the BST pin it should work. I got the same screen in the post today, and it took me 10 minutes to read the chip's name because the te...

I made this schematic for a pi3, but you can just replace the PP pads with the outputs of your low pass filter (except ground). You'll need two low-pass filters connected to two PWM sound outputs for stereo sound by the way.

@abrugsch is working on a way to read real GB cartridges here: http://www.sudomod.com/forum/viewtopic.php?f=9&t=2178

Unfortunately not, the Pi's video chip only supports one kind of video output at once, and can't support multiple monitors.

Bmo PI wrote: ↑

Tue Sep 26, 2017 9:50 am

Okay, the game boy cartridge I have now missing where I will solder on the card the cartridge player of gameboy?

If you just want the cartridge for looks, you don't need the cartridge reader.

How are you going to make the hinge? If you are going to route the cable through the hinge you'll have to make a hollow inside the hinge axis.