Teensy 2.0 vs Teensy LC?

General GBZ-related chat goes here. Share ideas, tips and tricks, or ask questions that don't fit into the hardware/software help forums.
Post Reply
Clearmoon247
Posts: 7
Joined: Sat Jul 02, 2016 10:27 am
Been thanked: 2 times

Teensy 2.0 vs Teensy LC?

Post by Clearmoon247 » Sat Jul 02, 2016 12:00 pm

I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.

Has anyone tried using a 2.0 in place of the LC?

User avatar
wermy
Site Admin
Posts: 1346
Joined: Tue May 03, 2016 8:51 pm
Has thanked: 620 times
Been thanked: 1322 times
Contact:

Re: Teensy 2.0 vs Teensy LC?

Post by wermy » Sat Jul 02, 2016 12:04 pm

Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.

Has anyone tried using a 2.0 in place of the LC?
Yep, Teensy 2.0 should work but I think it's a fair amount more than the LC (and the LC is even expensive for a little Arduino board tbh, it's just what I had on hand). Check out the wiki for some cheap alternatives! :)

sudomod.com/wiki
ImageImageImageImage

Zeryu
Posts: 3
Joined: Mon Jul 04, 2016 11:38 am
Has thanked: 1 time
Been thanked: 1 time

Re: Teensy 2.0 vs Teensy LC?

Post by Zeryu » Tue Jul 05, 2016 3:32 am

Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.

Has anyone tried using a 2.0 in place of the LC?

Hey ,

I used the Teensy 2.0 and it works just fine with Wermy's code.

Cheers

cvp
Posts: 20
Joined: Wed Aug 31, 2016 12:11 pm

Re: Teensy 2.0 vs Teensy LC?

Post by cvp » Wed Aug 31, 2016 12:21 pm

Zeryu wrote:
Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.

Has anyone tried using a 2.0 in place of the LC?

Hey ,

I used the Teensy 2.0 and it works just fine with Wermy's code.

Cheers
and can i solder the wire in same place? or will it use different places? And you don't overwrite the config with different parameters ?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest