I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Teensy 2.0 vs Teensy LC?
-
- Posts: 7
- Joined: Sat Jul 02, 2016 10:27 am
- Been thanked: 2 times
- wermy
- Site Admin
- Posts: 1346
- Joined: Tue May 03, 2016 8:51 pm
- Has thanked: 620 times
- Been thanked: 1322 times
- Contact:
Re: Teensy 2.0 vs Teensy LC?
Yep, Teensy 2.0 should work but I think it's a fair amount more than the LC (and the LC is even expensive for a little Arduino board tbh, it's just what I had on hand). Check out the wiki for some cheap alternatives!Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?

sudomod.com/wiki
Re: Teensy 2.0 vs Teensy LC?
Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Hey ,
I used the Teensy 2.0 and it works just fine with Wermy's code.
Cheers
Re: Teensy 2.0 vs Teensy LC?
and can i solder the wire in same place? or will it use different places? And you don't overwrite the config with different parameters ?Zeryu wrote:Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Hey ,
I used the Teensy 2.0 and it works just fine with Wermy's code.
Cheers
Who is online
Users browsing this forum: No registered users and 1 guest