Fleders GBZ incl. parts – incl. shop list for DE/EU

[agarajag]

Hello @fleders

Nice job . I have the same screen.
How did you make the screen cover?

Thank you

[crispy_tofu]

@agarajag
This might be useful: http://sudomod.com/forum/viewtopic.php? ... p=836#p838

[Fleder]

Hello @fleders

Nice job . I have the same screen.
How did you make the screen cover?

Thank you

Hi agarajag,

as tofu said, I did it nearly the same way, with a really sharp knife.
Just put the original screen on top and go over the edges again and again until you cut it through.
I used a nail file to smooth the edges, since my dremel would be too rough.

This is only a test, since I want to get laser cut screens, but it came out quite nice for a DIY.

[Bubble]

Nice thread & great work Fleder. Will keep watching this

[agarajag]

Hello @fleders

Nice job . I have the same screen.
How did you make the screen cover?

Thank you

Hi agarajag,

as tofu said, I did it nearly the same way, with a really sharp knife.
Just put the original screen on top and go over the edges again and again until you cut it through.
I used a nail file to smooth the edges, since my dremel would be too rough.

This is only a test, since I want to get laser cut screens, but it came out quite nice for a DIY.

cool!!
I'm going to try

[solder]

Nice progress, will prolly use your buttonwells tip :3

[Fleder]

Nice progress, will prolly use your buttonwells tip :3

[Fleder]

finished my frankenstein controller board (bigger picture in the first post):

[crispy_tofu]

For a moment I thought that the tape was solder wick...
Looking good! I like how you put in some strain relief by threading the wires through the PCB.

[chiz]

@Fleder
I can see we have a different PCB and this one you have seems easier to cut as it has ample clearance between the circuits. Were you able to still make the controller work via USB?