[FOR SALE] microSD-to-Cartridge Breakout Boards aka 'kk_gb_zero' [WORLDWIDE]

[spacegravy]

@Spaddel

You have pm for the adapter.

[Spaddel]

[mention]Mazzinator[/mention], I need some information from you - please read my PN

[Coreygunz25]

quick question how do you wire up rev c?

[kitsch-bent]

quick question how do you wire up rev c?

the same way as revA and revB. the wiring approach did not change. around page 6 or 7 of this thread there is a wiring diagram someone has made to make it easier...

[heepdriver]

Has anyone else verified the wiring? I wired my up the way that Flowlance did on page 6 and fried 2 sd cards. I found a pinout for an SD card on Google and it doesnt match. I do have a 1.3 version Zero, but I have confirmed that 3.3v is pp8 and GND is on pp6.

Thanks,
Brian

[zerocrash]

I recommend using a3k4's wiring guide for the 1.3 pi. I have a 1.3 and used his wiring guide for the sd card successfully and I have a rev c cart.

[heepdriver]

Thanks Zerocrash. I'm missing something simple here I think. Is this the correct pinout for a micro SD? IThe first two times I it was connected the same as A3K4's except I used pp6 as the ground. My SD cards actually smoked. I hope the diagram attaches correctly.

sd-card-pinout.png (58.5 KiB) Viewed 9872 times

.

Tx

[heepdriver]

I found the problem, pin 4 in the socket was bent and shorted to pin 3. Of course I totally destroyed three 32 G SD cards, but that's part of doing it yourself. Thanks for all the help.

Brian