oxy93n wrote:is there any wireing diagram on the forum?
Camble wrote:
- Octagonal BAT connects to the Bat or Vs pin of the PowerBoost.
- Octagonal EN connects to the EN pin of the PowerBoost.
- Octagonal GND connects to the GND pin of the PowerBoost.
- Octagonal LBO connects to the LBO pin of the PowerBoost.
Click here for the Raspberry Pi pinout.
- Circular 3.3v is the 3.3v pin (physical pin 1 or 17)
- Circular On is the keep-alive pin, usually BCM/GPIO22 (physical pin 15)
- Circular Off is the shutdown pin, usually BCM/GPIO27 (physical pin 13)
- Circular Low is the low battery pin, usually BCM/GPIO17 (physical pin 11)