How to modify THIS Gearbest screen for 5v?

ylwsub68 · Post by **ylwsub68** » Mon Mar 27, 2017 4:16 pm

The wiki does not show my particular board, and a search of the forums found someone who asked how to do it, made another post that they had succeeded, but then did not respond when someone else asked how they did it.

Picture of my board is attached. Also are there any other mods that need done to fix resolution, flickering, brightness, etc on this board? Might as well ask since I have your attention

Thank you!

Brandonmel · Post by **Brandonmel** » Fri Mar 31, 2017 12:15 am

I too am waiting for this in them mail i would like to know if i need to do anything to convert it to 5v.
from what ive read there isnt any need of modification but just to be 100 percent i will be following this post
thanks guys

ylwsub68 · Post by **ylwsub68** » Fri Apr 07, 2017 6:30 pm

No one? No ideas?

Brandonmel · Post by **Brandonmel** » Thu Apr 13, 2017 12:10 am

I saw this on a post I haven't tried it

fraggle · Post by **fraggle** » Mon Apr 17, 2017 4:52 pm

You would just put a wire as shown in red blow...

: 1490652941094731113295.jpg (835.07 KiB) Viewed 12070 times

ylwsub68 · Post by **ylwsub68** » Mon Apr 17, 2017 5:58 pm

Do I still use the through holes for this modification or the connector?

fraggle · Post by **fraggle** » Mon Apr 17, 2017 6:54 pm

I'm not sure what you mean. If you mean at the input its up to you - personally if you have the space I'd leave the JST in place.

ylwsub68 · Post by **ylwsub68** » Mon Apr 17, 2017 7:50 pm

There are through hole soldering points for 3v3 and other things by the center chip. I was under the impression that those were used for powering the board and transmitting the video signal.

Post by **Lphillimore** » Wed Apr 19, 2017 1:48 am

I have recently used this board and with the modification as stated above.

My advice is to leave the connector in place and not play around with the soldering points / holes.

This 5v mod should take 5mins then you're set.

Brandonmel · Post by **Brandonmel** » Mon Apr 24, 2017 7:27 pm

Can you please post a picture of what you did

How to modify THIS Gearbest screen for 5v?

How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Re: How to modify THIS Gearbest screen for 5v?

Who is online