Hi everyone,
After searching for a Raspberry footprint for the EagleCad and finding only that it has no bottom pads (and I need with bottom pads), I decided to create my own footprint.
I uploaded it to my github, here is the link:
https://github.com/vitalibr/rpi-zero-eagle
Enjoy!
[Eagle] Footprint of Raspberry Pi Zero with Bottom Pads
Re: [Eagle] Footprint of Raspberry Pi Zero with Bottom Pads
This is great work!
Recommendations
1. mirror the tDocu (51) layer to bDocu (52) 2. 2x20 header... ...square via the correct end 3. PP5 isn't used by most Gameboy Zero builds, you can get rid of it 4. You can additionally get rid of the HDMI test points (39,36,20)
5. Labels are nice
Drill holes are removed as this will impact your design as well
Reference
Recommendations
1. mirror the tDocu (51) layer to bDocu (52) 2. 2x20 header... ...square via the correct end 3. PP5 isn't used by most Gameboy Zero builds, you can get rid of it 4. You can additionally get rid of the HDMI test points (39,36,20)
5. Labels are nice
Drill holes are removed as this will impact your design as well
Reference
Who is online
Users browsing this forum: No registered users and 1 guest