Sound output pwm wont work(SOLVED)

[TilenB]

testb_bb.png (184.71 KiB) Viewed 9266 times

the sound wont work... now let me explain my wiring(pi to amp)
-I am doing only mono, this is why only one half of the low pass filter
-yellow wire out of low pass filter goes to the potentiometer
-I accidently bought a stereo amp, this is why I bridged the connection that comes out of the potentiometer to L+ and R+
-same goes for R- and L- which are connected to ground
amp out:
L- & R- = headphone ground
L+ =Left in
R+=Right in
Speaker + = Left out
Speaker - = Headphone ground

what am I doing wrong?

[moosepr]

Have you added the command into the config file to activate the sound?

https://learn.adafruit.com/adding-basic ... -pwm-audio

[TilenB]

yes I have.

[Lphillimore]

That doesn't look like the right PWM pin you're using on the Pi.

PWM audio on the Pi uses pins 13 and 18 by default and as per config change.

See purple and blue as below.

20170517_152756.png (1.12 MiB) Viewed 9248 times

[TilenB]

this is my wiring on the rpi red cable is pin 18 i think or have I counted wrong?

[moosepr]

yeah your in pin 24



just dont forget to mirror it, as the diagram is from the top, and your photo is from the bottom

[Lphillimore]

@TilenB - how did you get on?

[TilenB]

@TilenB - how did you get on?

I resoldered it now I'm gonna do the programming again I'll tell you if it works when I'm done

[TilenB]

nah still cant get it to work I really dont know what the problem is

[TilenB]

could the volume wheel be the problem?..
Pins from left to right:
1- empty
2- R out
3- R in
4- empty
5-ground