[For Sale] PRS-Tech Micro SD Cart board with Advanced Filtering

[Frigo]

Just ordered two !!!

[silentjames]

Hello @prerunnerseth!
As I can see, you board has 10 connectors on the left side. Can I use them to put leds inside the cartridge, oк these connectors are necessary for any other purposes?

[prerunnerseth]

Hello @prerunnerseth!
As I can see, you board has 10 connectors on the left side. Can I use them to put leds inside the cartridge, oк these connectors are necessary for any other purposes?

Thats what they are there for!

[Frigo]

I ordered 2 cart, but I recieved just one...

By the way, I'm interested to know how to put led on the conector.

[Frigo]

Recieved the second one! thank you

[silentjames]

Hey guys, I have a question about wiring. Following the wermy's guide, I've connected first, third, fifth and other pins to relevant PP-pins on the Pi Zero. But when I plug the cartridge with PRS board, Pi Zero doesn't start. No leds activity, nothing. When I put the microSD cart to Pi directly, it booted fine.
Someone in this thread described similar problem, but that was related to damaged microSD reader. Mine looks and fits right. I've discovered the forum and found the advice to keep the wires as short as possible - did it without any result. Also changed PP8 and PP8 pins to 3v3 and ground pins from GPIO - no result too.
What's wrong with my wiring?

SpoilerShow

[prerunnerseth]

Hey guys, I have a question about wiring. Following the wermy's guide, I've connected first, third, fifth and other pins to relevant PP-pins on the Pi Zero. But when I plug the cartridge with PRS board, Pi Zero doesn't start. No leds activity, nothing. When I put the microSD cart to Pi directly, it booted fine.
Someone in this thread described similar problem, but that was related to damaged microSD reader. Mine looks and fits right. I've discovered the forum and found the advice to keep the wires as short as possible - did it without any result. Also changed PP8 and PP8 pins to 3v3 and ground pins from GPIO - no result too.
What's wrong with my wiring?

SpoilerShow

The wires still seem pretty long. i would try to make them a little shorter. I'm not familiar with that connector.

[silentjames]

The wires still seem pretty long. i would try to make them a little shorter. I'm not familiar with that connector.

I uploaded the photo I've taken before the cutting wire. Now they are about 2 inches (or even less), but still not working.

[Frigo]

Hey guys, I have a question about wiring. Following the wermy's guide, I've connected first, third, fifth and other pins to relevant PP-pins on the Pi Zero. But when I plug the cartridge with PRS board, Pi Zero doesn't start. No leds activity, nothing. When I put the microSD cart to Pi directly, it booted fine.
Someone in this thread described similar problem, but that was related to damaged microSD reader. Mine looks and fits right. I've discovered the forum and found the advice to keep the wires as short as possible - did it without any result. Also changed PP8 and PP8 pins to 3v3 and ground pins from GPIO - no result too.
What's wrong with my wiring?

SpoilerShow

I've got excactly the same problem....

[SuperNova]

Ok, this will be my start on my own GBZero build.