DMG1 clear replacement screen protectors

[razor]

@kitsch-bent I'd be in for a glass one as well.

[evil_BaD_one]

@kitsch-bent I'd be in for 2 as well.

[hencethus]

FYI, Hand Held Legend sells clear glass screen covers with no adhesive:
https://handheldlegend.com/collections/ ... 9634764355

[SidSilver]

@kitsch-bent I'd be in for a glass one as well.

[GnobarEl]

I would like to have 2 as well, it will also depends on the price plus postage. But yes, I like this idea!

It will be like the original size with the right button corner round or it will be a full size? The bottom right corner just like the other corners. (if you understand what I mean...)

[Kcj101]

Would these fit over the larger screen without the border of the original? I assume that would be the point for the Pi 0. Does anyone have a picture of how it looks?

[Camble]

I ordered up some polycarbonate, but would love a pair of glass ones if the shipping to the UK isn't too much.

[dirtybeagles]

Anyone have suggestions on how I could mount my screen protector? I do not have a bezel so I am wondering if anyone has some tips?

2016-06-15 14_10_50-DirtyBeagles Build_Progress - Page 11 - sudomod.png (363.19 KiB) Viewed 10146 times

[Kilren]

Anyone have suggestions on how I could mount my screen protector? I do not have a bezel so I am wondering if anyone has some tips?

2016-06-15 14_10_50-DirtyBeagles Build_Progress - Page 11 - sudomod.png

If it is a real tight fit, I'd pop out your lcd and use either superglue or CA glue on the tiny edge of the screen and push it in place from underneath. As long as you're real slow, patient, and have still hands it'll work.

If you worry about the mess, then the other idea would be to push off the lcd. Put in the screen and use masking tape in the four corners. Flip the GBZ upside down (so you're looking at the guts) and use epoxy in the four corners as thin as you can get over the edge.

[Thijs852]

Anyone have suggestions on how I could mount my screen protector? I do not have a bezel so I am wondering if anyone has some tips?

2016-06-15 14_10_50-DirtyBeagles Build_Progress - Page 11 - sudomod.png

I lasercut mine slightly bigger and them used sanding paper to make it just the right size. It is a reallocate tight fit and i did not have to use any kind of glue.