Pink was the only color on eBay for a broken console when I looked--I don't want to break functioning consoles.
![Image](http://imgur.com/STuFnKq.jpeg)
Initial teardown photos:
Unit length
![Image](http://imgur.com/gP5ethj.jpeg)
![Image](http://imgur.com/UG9zlei.jpeg)
![Image](http://imgur.com/T3eogrD.jpeg)
![Image](http://imgur.com/4HSMJMA.jpeg)
![Image](http://imgur.com/yFU7Utg.jpeg)
![Image](http://imgur.com/lTurpdN.jpeg)
![Image](http://imgur.com/7MbgVyu.jpeg)
![Image](http://imgur.com/wgoUCrg.jpeg)
![Image](http://imgur.com/iaQcfyN.jpeg)
![Image](http://imgur.com/U8AEqQv.jpeg)
![Image](http://imgur.com/JAMnmM2.jpeg)
![Image](http://imgur.com/5TRJ33H.jpeg)
![Image](http://imgur.com/Bzlu9re.jpeg)
Thanks for looking!
(hopefully I'm not pointing out the obvious, but) You'll need to mod the case to fit that battery. It won't fit in the AA bay:
Not at all! I was going to remove the inside of the battery compartment and squeeze the cell in there. With the internals meant to hold a AA in there, I think it will have room. I think I might have one sitting around that I can test fit / mockup in the next few days.
I held it up late last night when I had a spare moment and it'll be a tight fit, but it will fit (might need to notch a few things). I'd be open to other battery options as well but it seems easier to have the 18650 with a higher capacity than a 1S 2500mAh lipo obscuring half of the rear case. Plus the 18650 COULD be removable and swappable if I get thrifty with plugs.
Some of those are pretty good actually lol.
Got a few saved on Amazon. Debated getting the button tops with protection built in but those are 10mm taller or so, would be a rough time fitting it all. The contrast pot is right there and I wanted to salvage that section of pcb and tap off of it but I could just use a new one.
Users browsing this forum: No registered users and 1 guest