Fleders GBZ incl. parts – incl. shop list for DE/EU

[Fleder]

Man, that inner-dip on the buttons is VERY nice -- well done!

Thank you

Very nice to read your wip.
I just ordered my Zero Pi on this site, if you did not yet found

http://www.kubii.fr/nano-ordinateurs-ra ... 03415.html

Thanks, but i finally was able to get one from ThePiHut Just forgot to update it.
Now the waiting begins.

[Kharmeleon]

Hello Fleder, could you tell me what a creme developer is in german? I don't get it in english and the translator doesn't give me a proper translation of it. Greetings

P.S. Very nice project you have there!! Especially i like that inner dip of the button holes and the bleaching is very sexy too Why didn't the writings disappear after bleaching?

[Fleder]

Hello Fleder, could you tell me what a creme developer is in german? I don't get it in english and the translator doesn't give me a proper translation of it. Greetings

P.S. Very nice project you have there!! Especially i like that inner dip of the button holes and the bleaching is very sexy too Why didn't the writings disappear after bleaching?

Hi there. Sure, it's called "Entwickler Creme" or "Creme Entwickler". Just stop by at your local Barber Shop and ask them to fill you some of this stuff into a bottle, they buy this in bulk, so it should be pretty cheap. Just go with the 12% or 40vol. stuff, if they ask you which.

I am no chemist, but i think the colour is not affected by the developer. It is not that aggressive, or you would have no hair after dying with it

[Deadtime]

Then you have to widen D-Pad hole, because the one from the SNES is bigger. Also, the Start + Select Buttons do not fit out of the box. Only ABXY do have the same size.

Damn. Thanks for sharing this info. Fleder, I haven't taken apart my Gameboy yet because I am waiting for the last parts to arrive. Only need a screen now. I do like the one you had but it has such big bezels. :/

[Fleder]

You're welcome.
That is a problem for me too, since i wanted to use the SNES Board for the buttons instead of the old one from the GB.
But they have 1 tiny spot to close the circuit instead of two, so this might not work.

[yves1984]

look at adafruit
they also use a snes controller and it works

https://learn.adafruit.com/pigrrl-raspb ... y/overview

[Fleder]

look at adafruit
they also use a snes controller and it works

https://learn.adafruit.com/pigrrl-raspb ... y/overview

Yes, but they do not use the buttons of one and the board of another. Also, their SNES Controller is slightly different, and that is the problem here

[crispy_tofu]

Not to mention that they 3D printed the case...

[Deadtime]

look at adafruit
they also use a snes controller and it works

https://learn.adafruit.com/pigrrl-raspb ... y/overview

Yes, but they do not use the buttons of one and the board of another. Also, their SNES Controller is slightly different, and that is the problem here

Fleder, Popcorn was selling some PCBs maybe he has someone some left, I am sure you can use those actually. The SNES board is a bit too long to fit in the Gameboy or you can look at Chiz's GB. He used the board of the SNES controller.

[Fleder]

Thanks, I already ordered 2 from Popcorn, but to get better at soldering and electronics in general, I wanted to test myself on this.