3D-Printed Arduino Christmas Countdown Ornament

YouTube · Post by **wermy** » Sun Dec 03, 2017 11:11 pm

Pretty much all in the title.

Figured I'd post it here so more folks could see it.
http://www.sudomod.com/3d-printed-ardui ... -ornament/

Post by **Helder** » Mon Dec 04, 2017 11:01 am

Cool beans and plenty of time to get one made in time for Christmas.

neolith · Post by **neolith** » Tue Dec 05, 2017 2:52 am

Oooooh – a post with a long video! Thank you, I am looking forward to watching this!

di993r · Post by **di993r** » Thu Dec 07, 2017 12:24 pm

Noob question but can i run the sketch on a teensy lc?

YouTube · Post by **wermy** » Thu Dec 07, 2017 12:39 pm

di993r wrote: ↑
Thu Dec 07, 2017 12:24 pm
Noob question but can i run the sketch on a teensy lc?

Their product page says it supports I2C, so yeah it should work, the SDA/SCK pins might be different than I used, though.

di993r · Post by **di993r** » Thu Dec 07, 2017 1:05 pm

Thanks. pins 18 and 19 are ic2 but the upload fails compilling. would i need to edit sketch?

YouTube · Post by **wermy** » Thu Dec 07, 2017 1:17 pm

what error are you getting? You may be missing a library or two.

di993r · Post by **di993r** » Sun Dec 10, 2017 5:18 am

'DS3231_INTCN' was not declared in this scope
Also now have the same board you used in the video

YouTube · Post by **wermy** » Sun Dec 10, 2017 11:20 am

di993r wrote: ↑
Sun Dec 10, 2017 5:18 am
'DS3231_INTCN' was not declared in this scope
Also now have the same board you used in the video

di993r · Post by **di993r** » Sun Dec 10, 2017 11:47 am

Thanks. just done both but same error.