MintyPi XL - The Remix

[YaYa]

Thanks mate ! I’ll make one in January

[dryja123]

Yay! I'll make sure you're rewarded when I get some holiday $$

[Pierre]

Super idea, super design thanks made a donation because I will be doing this build. Question about your 3D print. What type of materiel did you use?

[HoolyHoo]

Super idea, super design thanks made a donation because I will be doing this build. Question about your 3D print. What type of materiel did you use?

Thanks for that! I printed mine in PLA at .2mm with 30% infill without any issues.

[Pierre]

Cool. How did you get it so sharp and smooth? Sandpaper, chemicals?

[HoolyHoo]

Cool. How did you get it so sharp and smooth? Sandpaper, chemicals?

No sandpaper or chemicals. What you see in that first post is how it came off the printer. The results are the benefit of a well tuned Prusa MK2S.

[Pierre]

I see. Mine did not come out so nice.

[dryja123]

That's a fine looking print if you ask me.

[Pierre]

I will pass on the complement to the guy that printed it locally for me. I'll try to smooth the edges tomorrow. Thanks again for the model. Now time to build it.

[HoolyHoo]

I will pass on the complement to the guy that printed it locally for me. I'll try to smooth the edges tomorrow. Thanks again for the model. Now time to build it.

Awesome! How is the snap fit on that print?