[FOR-SALE] Slim 4 Soft Back Button PCB, Caps and 3D Parts (OPEN)

[HoolyHoo]

Hi Hoolyhoo

Do you have the A101 buttons in grey? from the picture is hard to see clearly.

Yes. It is a light grey but it is grey.

[rogerfliporian]

Ordered, arrived, and installed and these buttons look and feel great!
I did have a small alignment issue with one button hole like a previous poster but was able to mostly correct it. I suggest going very slowly and hand turning your bit. More important than alignment with the caps and the button membranes (there is a bit of wiggle room here) is ensuring that your holes are centered/aligned with each other so that they look as good as Hoolyhoo's OP image.

[Moonsword]

Is there a way I can order one of these and an AIO bracket and combine them together in one parcel to save a bit on postage?

[HoolyHoo]

Is there a way I can order one of these and an AIO bracket and combine them together in one parcel to save a bit on postage?

If your in the US PM me and I can combine. International orders not possible because brackets and pcb coming from two different locations.

[Moonsword]

Is there a way I can order one of these and an AIO bracket and combine them together in one parcel to save a bit on postage?

If your in the US PM me and I can combine. International orders not possible because brackets and pcb coming from two different locations.

Unfortunately, I am in Aus.

[Moonsword]

Hi Hooly,

I have a question that is slightly off topic. With the fan mount that you designed, have you tried it with Kite's CS and if so, where does it sit above the Pi?
I am asking as I am looking at grabbing a game that doesn't work and doing something similar with the cartridge.

[HoolyHoo]

Hi Hooly,

I have a question that is slightly off topic. With the fan mount that you designed, have you tried it with Kite's CS and if so, where does it sit above the Pi?
I am asking as I am looking at grabbing a game that doesn't work and doing something similar with the cartridge.

Yes I have tried it as it was designed for it. It is almost right on top of the pi. I’m sure with a little modification you can do something similar with an actual cartridge.

[Siniko]

The inserts for these were not pictured, but do they look similar to these?

SpoilerShow

BB2.jpg (228.19 KiB) Viewed 15088 times

The image was taken from the "Universal Button L1, L2, R1, R2 Back Button PCB" sale thread. I'm guessing they would somewhat be the same albeit a little smaller maybe?

[Kayumba]

What about guide for drill holes in right place?

[HoolyHoo]

What about guide for drill holes in right place?

The pcb has holes that are centered where buttons go so built in drill guide. Just mark before soldering the buttons to the pcb.