[Sold Out] Safe Shutdown v1.0 for BangGood/GearBest/Generic power Supply

[Merlin]

This is normal behaviour.
It works like an on/off switch.
For safe shutdown you need to install script.

[keithxboxv1]

Hey are these still available

[Merlin]

Any news about a fix in the script?
Version 1.02 still hangs the system when battery goes low!

[Camble]

I am running short on these boards. They're not as popular as the PowerBoost edition and cost quite a bit more to produce, so it's unlikely I will be restocking once these are gone. I may do a cut-down board in future without low battery alert, which should reduce the cost slightly but that would depend on demand.

[Camble]

Any news about a fix in the script?
Version 1.02 still hangs the system when battery goes low!

I don't get much time to look at this stuff these days. I still have a change by guarnacciaa to test and merge in, so will probably take a look at this issue at the same time. Not sure when that will be though. Will try to take a look soon.

[jcgonzalezdelgado]

I'm making my first build, and at first didn't consider the Safe Shutdown, but I love the functionality. The thing I'm planning (already bought) a display that uses DPI, so almost all the GPIO pins will be used for the display, as stated here:

https://www.raspberrypi.org/documentati ... rrypi/dpi/

My question is: with this board, the instructions wire to some specific pins:

Circular On is the keep-alive pin, usually BCM/GPIO22 (physical pin 15)
Circular Off is the shutdown pin, usually BCM/GPIO27 (physical pin 13)
Circular Low is the low battery pin, usually BCM/GPIO17 (physical pin 11)

But those pins are used no matter which mode of DPI you choose. Mi question is: can we use other free GPIO pins for this? or are they fixed?

Thanks!

[amee]

Hi, @camble

Please tell me will it work with this: https://ru.aliexpress.com/item/Elcrow-R ... Title=true Powermanager ? Will it completely remove power after shutdown, and can you deliver to Ukraine? Thanks

[rakoilo]

Do you share the schematic of this board? I'd like to know how the mosfet is connected.

[the_darkman]

Hi Camble, i ordered via paypal at 21.11.2018 and just wanted to know if you already shipped or how long it may take.

[sandog]

will this work and would this be a good idea to use with tinker boys newest board