HUD not showing after update

Post Reply
User avatar
cnobles
Posts: 9
Joined: Tue Oct 17, 2017 8:46 am
Location: Dallas, TX, USA
Has thanked: 10 times

HUD not showing after update

Post by cnobles » Fri Dec 28, 2018 10:33 am

I just tried to update my Circuit Sword in order to start showing the mode button hints on press, and now the HUD doesn't display at all (battery, wifi, etc). Any help would be greatly appreciated.

The only thing strange that may have occurred during the update was this error message:

Failed to stop cs-osd.service: Unit cs-osd.service not loaded.

It looks like this has also prevented the power switch from triggering the safe shutdown, so I've had to turn it off via the shutdown command instead.

User avatar
cnobles
Posts: 9
Joined: Tue Oct 17, 2017 8:46 am
Location: Dallas, TX, USA
Has thanked: 10 times

Re: HUD not showing after update

Post by cnobles » Wed Jan 02, 2019 1:52 pm

Does anyone have any ideas on this? Is it possible to do a fresh install without removing other settings on the system?

WoWin
Posts: 22
Joined: Mon Jun 26, 2017 12:11 pm
Has thanked: 17 times
Been thanked: 2 times

Re: HUD not showing after update

Post by WoWin » Fri Jan 04, 2019 7:45 pm

If you update from an old raspbian Jessie image than that is what happens, unfortunately. The new hud drawing needs some newer libraries which are only available on Stretch (if you don't want to compile yourself). My recommendation is to do a fresh install, after backing up files and settings.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests