KonnorJ wrote: ↑Fri Nov 30, 2018 9:27 am
bucky720 wrote: ↑Thu Nov 29, 2018 11:23 pm
Oh, I thought I remember reading they would have it out a little while ago and then once I saw Wermy's video I was really confused.
But 3r and r2 on the front above and also to the left of the screen. The rest have either the value listed or a table like on the back of the board.
Thank you.
Hey dude, 3R is your 3 ohm resistor from the Arrow BOM and the one labelled R2 next to the screen is your 1.5K ohm resistor from the arrow BOM, sorry for any confusion there!
For future reference, 3R, 100R 560R etc... all mean the resistance rating, (3 ohm, 100 ohm, 560 ohm) whilst R1, R2, R3 are just labels the EDA software assigns.
Awesome, thank you for the clarity. Yeah, I figured out the 100r and all that. I guess I was tired at the time to not put 3r together the same
Now to ensure those are correct and then wait for the image. It's like being a little kid again and staring at the presents under the tree until it's finally time to open them.
