Minty Pi V3 Buttons

[KillFace]

I am still working on finishing some V2 builds and I would like to use the new V3 buttons if possible. Does anyone know if these new buttons will be compatible with the previous mintypi versions?

[rodocop]

yeah, the face buttons (D pad and ABXY will be fine) (the start and select ones should work too, but they will press down a tactile button, rather than make contact themselves.). The shoulder buttons of the older versions used tactile buttons, so you will still need to use those.

[KillFace]

Awesome, thanks for the info!

[dryja123]

The print tolerances for V2 were slightly different so you may have to open up the button holes a bit. You'll have to test it out and see how it feels / fits

[rodocop]

Yeah. I used the silicone buttons on a minty pi XL. Using a v2 board. Mind you the minty pi XL is not the same, but it was designed using the original minty pi files, so I assume it would be very similar.

XL #2 https://imgur.com/a/xpVgOmA