question for thoe using the kitsch-bent cartridge

[chibilaharl]

Hi so i am a bit confused as to the pinout and which items go where.

is this correct?

VCC-pp8
dat2-pp18
cs- pp19
data_in -pp22
sclk-pp14
Data_out-pp23
dat1-pp17
GND- to any ground or pp6?


This doesnt seem to match up with wermy's. i dont use pp15,or 17, and i seem to have pp22 and 23 that wermy doesnt use.

[chibilaharl]

any ? im desperate

[jermzz]

I'm having the same problem. I dunno much about SD pins. I had it the same way you do, and the pi wouldn't even turn on. As soon as I put the card in the pi itself, it booted right up into retro pi.

Kb's pins seem different. Either way, seems the way you have it up there (the way I did it too) doesn't work for me. Maybe I should try the other pins that wermy uses.

[Kalen]

No resolve on this? I'm planning on using the same SD cartridge

[gnarlynick]

Based off this chart I was able to mock up a quick and dirty guide. I haven't been able to test it as I was having trouble getting the SD socket soldered to the board so give it a shot and let me know. I do know PP22 & PP23 are Data + & - for the USB interface, that should be used for the USB hub/Teensy. All SD pads are on the one side of the board.

MSDPinouts.jpg (187.59 KiB) Viewed 7182 times

[spoiler="Guide"]

kk_gb_zero_hookup.jpg (249.87 KiB) Viewed 7182 times

[/spoiler]

[hueblo]

Unnecessary but I can confirm the guide is correct.