hey
this is my first big soldering project, so I'm not that good with electronics yet
thought I'd try to make a GBZ, so I got all pieces and have been following a guide I've found with exactly the same pieces as the ones I have
one step was to remove a plastic cable case (?)
and direct solder the wires, but one "point" [AV1] came loose from the entire board
after some cursing I tried to just use AV2 instead, since the guide only uses one anyway, along with ground
..but nothing works
do I get a new screen or could there be something else I missed?
thanks
think I messed up the screen..?
Who is online
Users browsing this forum: No registered users and 1 guest