What parts could we make?

[skrapps914]

@wermy what about something like this, that can "plug"into the original modified power port, so it braces the micro USB breakout

[dirtybeagles]

@wermy, for those that are using the VGA screen that is pretty large, is it on the road map to get these brackets printed? It may be too small to print though which is what I am hearing from some printing shops.

[spoiler="my custom screw bracket"]

2016-07-12 13_40_50-DirtyBeagles Gameboy Pi2 - Page 3 - sudomod.png (1.36 MiB) Viewed 10126 times

[/spoiler]

[skrapps914]

extended/longer sized buttons with the same radius as the back shell dremeled screw sockets, to use as L/R buttons

[Fleder]

A bracket that would hold those rubber pads for my SNES shoulder buttons.
It is a PITA to cut something good enough out of plastic sheets.

[MauroS]

would be awesome if we could get files to print out this case and actually make this gameboy

WOW!!!! would be amazing!

[skrapps914]

@wermy what about something like this

Almost keeps the original look with the black surrounding

[Ganreizu]

for those that are using the VGA screen that is pretty large, is it on the road map to get these brackets printed? It may be too small to print though which is what I am hearing from some printing shops.

[spoiler="my custom screw bracket"]2016-07-12 13_40_50-DirtyBeagles Gameboy Pi2 - Page 3 - sudomod.png[/spoiler]

@wermy; rebuffing this question.

[wermy]

for those that are using the VGA screen that is pretty large, is it on the road map to get these brackets printed? It may be too small to print though which is what I am hearing from some printing shops.

[spoiler="my custom screw bracket"]2016-07-12 13_40_50-DirtyBeagles Gameboy Pi2 - Page 3 - sudomod.png[/spoiler]

@wermy; rebuffing this question.

Where can I see more pictures of this setup? Hard to see exactly how it works. Are new holes drilled in the back right at the top?

[Ganreizu]

Where can I see more pictures of this setup? Hard to see exactly how it works. Are new holes drilled in the back right at the top?

We had a conversation about this somewhat earlier in the thread, beagles just seemed to make a screw post bracket somehow. The build just needs something like a latching bracket that holds the top of the case together.

Something like this: http://i.imgur.com/vxiDTQC.jpg

[wermy]

Where can I see more pictures of this setup? Hard to see exactly how it works. Are new holes drilled in the back right at the top?

We had a conversation about this somewhat earlier in the thread, beagles just seemed to make a screw post bracket somehow. The build just needs something like a latching bracket that holds the top of the case together.

Something like this: http://i.imgur.com/vxiDTQC.jpg

Ah I remember, so no screws at all eh? I bet I could work something out.