Difference between revisions of "GBZ Misc Hardware"
(→Power Switch: Added links to switch with side terminals. The originally linked switch with bottom terminals doesn't fit very well in the DMG case.) |
(→Power Switch: Replaced eBay UK link with one that isn't OOS) |
||
| Line 14: | Line 14: | ||
If you don't have the power switch from the GBZ board or are unable to desolder it you can use [http://www.banggood.com/5pcs-6-Pins-Slide-Switch-OnOn-Vertical-Mini-Miniature-Terminals-p-993806.html?p=9B1915347037201311DI this switch]. | If you don't have the power switch from the GBZ board or are unable to desolder it you can use [http://www.banggood.com/5pcs-6-Pins-Slide-Switch-OnOn-Vertical-Mini-Miniature-Terminals-p-993806.html?p=9B1915347037201311DI this switch]. | ||
| − | Due to space constraints in the Gameboy DMG case, it may be advisable to use a replacement switch with terminals on the side, instead of the one listed above. [http://www.ebay.co.uk/itm/ | + | Due to space constraints in the Gameboy DMG case, it may be advisable to use a replacement switch with terminals on the side, instead of the one listed above. [http://www.ebay.co.uk/itm/20Pcs-6mm-High-Side-Knob-6-Pin-2-Position-DPDT-Slide-Switch-0-5A-50VAC-SK22H03/282012438100 Here], [https://www.amazon.com/0-5A-Horizontal-Slide-Switch-SK22H03/dp/B008DFYRG2 here], and [http://www.ebay.com/itm/20Pcs-6mm-High-Side-Knob-6-Pin-2-Position-DPDT-Slide-Switch-0-5A-50VAC-SK22H03-/282012438100 here] are some choices. |
==Micro SD Card== | ==Micro SD Card== | ||
Revision as of 18:10, 17 August 2016
Contents
GPIO PWM Audio for Raspberry Pi Zero
150 Ohm resistor, 270 Ohm resistor, 10nF capacitor, and a 33nF capacitor (another 10nF will work fine as well if that’s easier to find)
L/R Buttons
If you want to use tactile switches in the rear screwholes like the original GBZ, you'll need something similar to this: http://www.amazon.com/9-5mm-Momentary-Tactile-Button-Switch/dp/B008420WOA or this
Replacement case
A replacement case for the gameboy can be found here.
Audio Jack
In case you can not use the audio jack of the original GBZ board here is a replacement.
Power Switch
If you don't have the power switch from the GBZ board or are unable to desolder it you can use this switch.
Due to space constraints in the Gameboy DMG case, it may be advisable to use a replacement switch with terminals on the side, instead of the one listed above. Here, here, and here are some choices.
Micro SD Card
32 Gb micro SD card to install RetroPi on and roms.
Prototype PCB
Protoytype PCB to create power distribution board or GPIO sound output for the RPi Zero.
