Difference between revisions of "GBZ Misc Hardware"
(→Power Switch: Replaced eBay UK link with one that isn't OOS) |
m (→Micro SD Card) |
||
| Line 17: | Line 17: | ||
==Micro SD Card== | ==Micro SD Card== | ||
| − | [http://www.banggood.com/32GB-Class-10-Micro-SD-TF-Micro-SD-Card-For-Mobile-Phone-p-975787.html?p=9B1915347037201311DI 32 Gb micro SD card] to install | + | [http://www.banggood.com/32GB-Class-10-Micro-SD-TF-Micro-SD-Card-For-Mobile-Phone-p-975787.html?p=9B1915347037201311DI 32 Gb micro SD card] to install RetroPie on and roms. |
==Prototype PCB== | ==Prototype PCB== | ||
Revision as of 18:03, 14 March 2017
Contents
GPIO PWM Audio for Raspberry Pi Zero
150 Ohm resistor, 270 Ohm resistor, 10nF capacitor, and a 33nF capacitor (another 10nF will work fine as well if that’s easier to find)
L/R Buttons
If you want to use tactile switches in the rear screwholes like the original GBZ, you'll need something similar to this: http://www.amazon.com/9-5mm-Momentary-Tactile-Button-Switch/dp/B008420WOA or this
Replacement case
A replacement case for the gameboy can be found here.
Audio Jack
In case you can not use the audio jack of the original GBZ board here is a replacement.
Power Switch
If you don't have the power switch from the GBZ board or are unable to desolder it you can use this switch.
Due to space constraints in the Gameboy DMG case, it may be advisable to use a replacement switch with terminals on the side, instead of the one listed above. Here, here, and here are some choices.
Micro SD Card
32 Gb micro SD card to install RetroPie on and roms.
Prototype PCB
Protoytype PCB to create power distribution board or GPIO sound output for the RPi Zero.
