Wifi
-
- Posts: 3
- Joined: Sat Apr 25, 2020 11:25 am
Wifi
Currently I have everything soldered and what not, and am now working on the software... one problem. Every time I go and edit the WiFi from the sd card, when I go in the minty pi and look for my ip... it says unknown. Then when I pop the ad card back into the computer, the WiFi file is gone completely, I looked and searched but it says it cannot be found. I couldn't even add a new folder for it without it disappearing. What is the best instruction on adding my WiFi?
- LilTrublMakr
- Posts: 365
- Joined: Sun Aug 05, 2018 6:39 am
- Has thanked: 24 times
- Been thanked: 120 times
- Contact:
Re: Wifi
Make sure that you are using a 2.4 ghz network (it does not have a 5 ghz antenna) and a RaspberryPi Zero W. The non W variant (1.3) does not have wifi on it.
As far as the supplicant file, you can just make another one on the boot drive.
Edit the parts you need and name it "wpa_supplicant.conf" or you can use my generator located in the following link: https://codepen.io/LilTrublMakr/pen/yRGPrv
As far as the supplicant file, you can just make another one on the boot drive.
Code: Select all
country=US
update_config=1
ctrl_interface=/var/run/wpa_supplicant
network={
ssid="INSERT SSID HERE"
psk="INSERT PASSWORD HERE"
key_mgmt=WPA-PSK
}
@LilTrublMakr
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
Who is online
Users browsing this forum: No registered users and 1 guest