Hey all. As I was removing some kapton tape, I pulled off a section of trace for the start button on my Circuit Sword Lite. I’ve seen some videos for trace repair, and it seems pretty challenging for a soldering noob like me, but I don’t really have any other options. Based on the trace’s location, I’m worried the repair will impact the performance of my right button on the D-Pad.
Any thoughts or advice? I finally got my gbz built this summer, and I’m pretty crushed that I just messed it up.
Thanks.
Help repairing Circuit Sword Lite trace
Help repairing Circuit Sword Lite trace
- Attachments
-
- Broken Start Button Trace
- 0ED0FF99-F7B5-421A-B7FC-B1B90C8B4523.jpeg (2.33 MiB) Viewed 1351 times
- LilTrublMakr
- Posts: 365
- Joined: Sun Aug 05, 2018 6:39 am
- Has thanked: 24 times
- Been thanked: 120 times
- Contact:
Re: Help repairing Circuit Sword Lite trace
Trace looks in tact to me. As long as the trace is in tact, I would not worry about it. If it's not in tact, then a small solder bridge will fix it.
@LilTrublMakr
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
Who is online
Users browsing this forum: No registered users and 1 guest