How you wire the PSP Joystick with the CS? which cable comes where at the joystick?
Thanks in advance
How do I wire the Joystick? [Split from preorder thread]
- LilTrublMakr
- Posts: 365
- Joined: Sun Aug 05, 2018 6:39 am
- Has thanked: 24 times
- Been thanked: 120 times
- Contact:
Re: How do I wire the Joystick? [Split form preorder thread]
You should have 2 connectors that have wires that are green, red, black, and white. That is the connector you use (1 for if you are using a single joystick or both if you are using 2 joysticks). I cut mine to about 1cm for a joystick in the middle. As far as soldering goes, I am assuming you have a PSP1000 joystick and the soldering goes as follows:
Once soldered you can pull the wires through the hole in the middle of the board and connect it like so:
Once soldered you can pull the wires through the hole in the middle of the board and connect it like so:
@LilTrublMakr
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
Who is online
Users browsing this forum: No registered users and 1 guest