[For Sale]HoolyHoo's AIO bracket for Kite's Circuit Sword Board

[HoolyHoo]

Good news everyone!

I tested the SNES screen bracket with wells on Helder's latest board and it works just as good. The only thing is since there are four post on the bracket you obviously can't put the L1 and R1 buttons where Wermy did it in his build unless you want to remove the bottom post of the brackets which is doable. Also screen has to be mounted upside down and flipped in software which is no big deal. Everything else works great including the X and Y button holes which line up as I expected. Here is a photo.

ScreenHelder.jpg (1.51 MiB) Viewed 12638 times

I modified the top of this bracket because I plan on placing the L1 and R1 like I did with Kites build. I like them there because they are easy for me to use there plus they are on the same side of the board which means less wiring across the two halves.

[davcra]

Any chance getting this shipped to Australia?

[platta]

hi,

sorry for the dump question but are there different sizes? I received the bracket from printing but seems too small. the screw holes do not fit together ;(

br

Platta

[Billy Blaze]

hi,

sorry for the dump question but are there different sizes? I received the bracket from printing but seems too small. the screw holes do not fit together ;(

br

Platta

nope!
but it depends on the printer and the material you're using. and it seems that your material did just shrunk a bit. to prevent this phenomenon you (or your print service) might want to upscale the bracket before printing. I gave it +1% and it fits perfectly fine. normally your 3D print service should have advised you in such things...

my printed bracketShow

printed mine. everything fits quite well. thanks again for this model!

[HoolyHoo]

Any chance getting this shipped to Australia?

Sure just make sure to select non UK US shipping.

[platta]

hi,

sorry for the dump question but are there different sizes? I received the bracket from printing but seems too small. the screw holes do not fit together ;(

br

Platta

nope!
but it depends on the printer and the material you're using. and it seems that your material did just shrunk a bit. to prevent this phenomenon you (or your print service) might want to upscale the bracket before printing. I gave it +1% and it fits perfectly fine. normally your 3D print service should have advised you in such things...

my printed bracketShow

printed mine. everything fits quite well. thanks again for this model!

Thank you...will have a chat with them tomorrow

[cpeb]

Evening

What screen is this designed for, just had the bw variant 4 delivered.

Thanks

[HoolyHoo]

Evening

What screen is this designed for, just had the bw variant 4 delivered.

Thanks

Any of the common 3.5 inch LCD screen that are 320 x 240 in resolution. All the screens in the wiki are the same dimension its just the controller board that vary.

[Modex007]

can anyone make PDF file with drill inserts 2d, that i could print 11mm cicles with center points on a4 paper ?

[cpeb]

Hi, i found this on the forum - not used it yet though
http://cpeb.co.uk/.Uploads/Front_holes_template.pdf

Remember to turn off shrink to fit etc before printing. Apologies to who designed the template, i cant remember who posted it originally.

Thanks