Screens

3.5" Screens for GBZ

Composite/TV Screens	Pros: Cheap Simple to install Usually only need 1 wire (plus power & ground). Cons: Low Resolution Analog nature makes them sensitive to interference and ghosting. Many different variations makes standardizing difficult.
SPI Screens	Pros: Often better resolution than Composite/TV screens Digital nature makes perfect picture clarity Typically needs 7-10 wires, more than Composite, but less than DPI. Cons: Often designed as "Hats" that sit on the pi taking up a lot of space and all the GPIO pins even if not needed. Can vary wildly on driver support. Even some well known sellers can unofficially EOL these by not updating drivers and install guides SPI has very low bandwidth, leading to stuttering and FPS issues. Are often 16:9 ratio rather than 4:3 like the Composite screens: Fitting into a GBZ may be difficult or impossible.
DPI Screens	Pros: Often very high (nearing cell phone ppi) resolution Amazing image quality Can reach 60fps Cons: The most expensive option Will use all or nearly all GPIO pins Often designed as "Hats", making them large & thick.

2.2" Screens for MintyPi

To-Do

Screens used by other projects seen around SudoMod

To-Do